Sealing machine cleaning and maintenance

Sealing machine cleaning and maintenance


Regularly clean the surface of the machine, the bottom plate and the lower mold slide, grooves, the upper mold inner pressure plate and the positioning rod (note: the power must be turned off and normal temperature must be restored).

Lower part slide plate, pressure bar bearing, eccentric wheel and guide post, guide rail and other transmission parts are regularly greased to ensure the performance of the machine.

To clean the tooth knife: First plug the two drain holes of the lower mold with a cotton ball, pour boiling water into the groove of the lower mold until it is full, then push the slide plate of the lower mold into place, press down and press the upper mold At the lowest point, let the tooth knife soak for a few minutes until it is clean, and repeat several times.