Use of pneumatic sealing machine

Use of pneumatic sealing machine

1. Turn on the power supply ~ 220V/50Hz, the power indicator light is on. Connect the gas source, equipped with air pressure: 0.4-0.6MPa, equipped with gas volume: 0.25 cubic meters/minute.

2. All pneumatic components and cylinder speeds inside the machine are adjusted and set at the factory. It is best not to adjust them again. If they do need to be adjusted, they should be operated under the proper guidance of professional technicians.

3. When the start button or foot switch is operated, it can be removed with just one jog without pressing. The cylinder is activated and the cylinder indicator lights.

4. Sealing time stopwatch adjustment: According to the material and thickness of the film used, set the appropriate sealing time (adjustable between 1-30 seconds), when the film is thin, please adjust the sealing time to 2-4 Between seconds, when the film is thicker, please adjust the sealing time to 4-10 seconds. Adjust the sealing time according to the sealing effect. When the stopwatch is adjusted to 0 gear, its working nature is empty operation, that is, the entire procedure is carried out as usual, but the sealing part is not heated. This function is very suitable for the adjustment and testing of the mechanical part.

5. Cooling time stopwatch adjustment: According to the material and thickness of the film used, set the appropriate cooling time (adjustable between 1-30 seconds), when the film is thin, please adjust the cooling time to 1-3 Between seconds, when the film is thicker, please adjust the cooling time to 2-4 seconds. When the stopwatch is adjusted to 0 gear, when the machine is working, there is no cooling time for the sealing.

6. The correct adjustment method of the air pressure valve: If the pressure of the pressure gauge is not within the specified range, the following adjustments should be made: gently pull the top cover of the regulator outward, and rotate the pressure clockwise to increase the pressure and counterclockwise to decrease the pressure Small, when adjusting the pressure, you must gradually and evenly adjust the required air pressure, and then press down the upper cover, so that the adjustment switch of the air pressure valve is normally closed.

Can keep the working pressure stable.

7. Pneumatic sealing machine belongs to electrical machinery products, the voltage should be consistent when used, the chassis must have a good protection grounding, the machine should be used for a period of time to tighten the screw nuts, the two joints should be timely added oil and oil-water separator Drain and drain water to ensure the normal operation of the machine.